156
CARE AND CLEANING
Protect your ATOM from shock, excessive temperatures,
exposure to chemicals, and tampering. Protect the lens against
scratches with a Instrument Lens Protector. Small scratches will
naturally disappear underwater.
Soak and rinse the ATOM in fresh water at the end of
each day of diving, and check to ensure that the areas
around the Low Pressure (Depth) Sensor (Fig. 143a), PC
Interface Data Port (Fig. 143b), and Buttons are free of
debris or obstructions. Soak and rinse the Regulator(s)
with the T ransmitter(s) attached.
To dissolve salt crystals, use lukewarm water or a slightly
acidic bath (50% white vinegar/50% fresh water). After
removal from the bath, place the ATOM and the
Regulator(s) with Transmitter(s) unit under gently running
water and towel dry before storing.
T ransport your ATOM system cool, dry , and protected.
INSPECTIONS AND SERVICE
Your ATOM should be inspected annually
by an Authorized
Oceanic Dealer who will perform a factory prescribed function
check and inspection for damage or wear. To keep the 2 year
limited warranty in effect, this inspection must be completed
one year after purchase (+/- 30 days).
Fig. 143 - ATOM CASE BACK
b
a
To Next Page
Loading...
Need help?
General
