176
If for any reason, the ATOM 2.0 shuts Off then turns On again
for any reason during any Dive, the message
ERR (Error)
will
be displayed with the Up Arrow and current Depth (Fig. 156).
If this occurs, it is highly recommended that you terminate the
dive and begin a safe ascent to the surface.
Upon surfacing, and any time thereafter, when access to Dive
Computer Operating Mode is attempted from Watch Mode, only
the message
ERR
will be displayed (Fig. 157).
No Dive Computer Modes/screens will be accessible.
If this occurs, the ATOM 2.0 must be returned to the factory for
evaluation/service prior to any further use for diving activities.
ERROR (RESET DURING A DIVE)
Fig. 156 -ERROR WHILE
DIVING
Fig. 157 -SURFACE AFTER
ERROR DURING A DIVE
To Next Page
Loading...
