41
If a dive has been conducted within the past 24 hours, the SURF
MAIN screen for that Operating Mode (NORM, GAUG, or
FREE) will be displayed.
At any time while operating in Surface Modes, the ATOM will
enter Dive Mode upon descent to 5 FT (1.5 M).
During the 2 hour pre dive surface period, if the M button is
pressed to access other screens in the Watch Mode
sequence, Surface Mode must again be accessed prior to
the first dive of a series (if WET ACTIVATION is set OFF).
When WET ACTIVATION is set ON, the Wet Contacts will
activate the selected Dive Mode regardless of what Mode
the ATOM is operating in at the time of the descent.
The ATOM will enter POST DIVE SURFACE MODE following a
dive upon ascent to 4 FT (1.2 M). The Surface Interval Time
colon will flash during the first 10 minutes after a NORM/GAUG
dive (Fig. 34), or 1 minute after a FREE dive.
During the first 10 minutes after a dive, the SURF MAIN screen
for the Operating Mode selected prior to the dive (NORM,
GAUG, or FREE) remains on display as the Default SURF MAIN
screen. Main Watch Time can be viewed for 5 seconds during
that period by pressing and releasing the M button momentarily
(less than 2 seconds).
Fig. 34 - NORM SURFACE
MODE
(Post Dive Unit WET)
To Next Page
Loading...
Need help?
General
