163
Place a new 3 volt, CR2, Lithium Battery (Duracell model DL-
CR2 or equivalent) positive (+) side down into the Battery
Compartment with the negative end facing up/out (Fig.
153).
Ensure that the Battery is properly oriented and the Hatch
O-ring is evenly seated around the Battery Hatch.
Carefully place the Battery Hatch with Spring into the
Housing and turn clockwise slowly by hand to ensure
proper threading. Apply a coin and tighten until secure.
The outer surface of the Battery Hatch should be flush with
the outer surface of the Housing (Fig. 154).
ATOM System Testing
Observe the LCD display to ensure it is consistently clear
and sharp in contrast throughout the screen.
Set the Date Time, Alternate T ime, and Daily Alarm.
Verify all Set Points prior to diving.
Pressurize the Regulator Assembly (and Transmitter).
Verify that the Link icon is displayed.
Press the S button for 2 seconds to check the Status screens.
If any portions of the display are missing or appear dim, or
if a Low Battery Condition is indicated, return your ATOM
to an Authorized Oceanic Dealer for a complete evaluation
before attempting to use it.
Fig. 153 - TMT BATTERY
ORIENTATION
Battery
(+) ( - )
Fig. 154 - TMT BATTERY
HATCH INSTALLED
To Next Page
Loading...
Need help?
General
