OEM FX - Reception of the Machine; Unpacking

FX / RVE
Transport and unpacking
EN - 9
1
1
2
Fig. 3
2.3 - RECEPTION OF THE MACHINE
Upon reception of the machine make sure that the pa-
cking is complete and not damaged. Should the packing
be complete, remove it as specify at point 2.4 (unless
otherwise instructed by the manufacturer).
Check if the instruction booklet is inside the packing
aswellasthe components specied in thetransport
documentation.
In case any damage or defect is found:
a- Inform immediately the transport company and your
agent, both by phone and by registered letter with
return receipt;
b- Inform the manufacturer as mentioned above, ad-
dressing the correspondence to:
OEM ALI Group S.r.l. a Socio Unico
Viale Lombardia, 33
46012 BOZZOLO (MN) Italia
Tel.: +39 0376 - 910511 - Fax: +39 0376 - 920754
2.4 - UNPACKING (Fig. 3)
To remove the packing from the machine proceed as
follows:
• Cutthestraps(1)thattieupthecarton.
• Openthecarton(2),byremovingthemetallicclips.
• Removethecardboardpackaging(2).
• Checkifeverythingiscomplete.
• CheckifthedeliveryiscomplyingwiththePACKING
LIST.
ATTENTION
All packing materials should be collected and sent to
the special recovery centres for a correct recycling.
IMPORTANT
Any damage or defect or non conformity with the
packing list should be immediately reported and, in
anycase,itshouldbenotiedwithin8daysfromthe
date of reception of the machine. On the contrary the
goods are to be considered as accepted.