OHAUS EXPLORER - Page 110

APPENDIX D - REPLACING BOTTOM DISPLAY BOARD
D-2
D.2 Explorer Pro, Voyager and Voyager Pro Display Flash Instructions
(Cont.)
3. Install the flash loader program by running the Setup.exe file and following the prompts of the
install shield wizard.
4. Unzip the required bank files into their own individual folder. This folder will contain bank files
with the extension .H00, .H01 … H0X . There will also be at least 1 text file named nlogo.txt.
Additional files may be present but are not essential
5. Connect your computer to the balance
6. Turn the balance on. The display will read Verify flash bank checksum followed by individual
lines for each bank and the status failed.
7. Use a program such as Hyper Terminal to test the communications from your computer to the
balance. The settings while the service pins are shorted are 9600 baud, Parity None, Data Bits
8, Stop Bits 1, Handshake None. Send the balance a V command to test communications. The
balance will respond with the software version.
8. Start the Flash Programmer from your programs menu. Note the communication settings and if
necessary change to match the communications port you are using.
You should not haveYou should not have
You should not haveYou should not have
You should not have
to change the other parameters.to change the other parameters.
to change the other parameters.to change the other parameters.
to change the other parameters.
9. The communications port settings are displayed at the top of the screen and can be changed by
clicking the “comm. setup” button and selecting the appropriate settings from the pick list.
PLEASE NOTE: THE “TEST COMM! “ Button does not function in this software. If you need to test
the communications use Hyper terminal or another program.