229
Example: Enabling FTP
1. Ensure that the display panel indicates that the printer is ready
to print.
2. Press the Enter button to switch to the Menu mode.
3. With [Configuration] highlighted, press the Enter button to
select this menu.
4. Press the ∇ or ∇ buttons repeatedly until [Admin Setup] is
highlighted.
5. Press the Enter button to select this item.
6. Press the ∇ or ∇ buttons to enter the first digit of the password,
then press the Enter button.
7. Repeat the previous step for each digit of the password.
8. Press the Enter button to go into the [Admin Setup] menu.
9. With [Network Setup] highlighted, press the Enter button.
10. With [Slot1:100/10 Base] highlighted, press the Enter button.
11. Press the ∇ or ∇ buttons repeatedly until [FTP] is highlighted.
12. Use the ∇ or ∇ buttons to highlight [Enable].
13. Press the Enter button to engage the setting.
An Asterisk (*) appears next to the new setting.
To Next Page
Loading...
Need help?
General
