Configuration: Using AdminManager Standard Setup • 36
SNMP Tab (Oki Device Setup)
Item Comments
Authentic
Community
This community name is used to check whether or not
incoming SNMP requests have the correct community
name. The community name is displayed as ****** for
security reasons.
TRAP
Community
This community name is assigned to outgoing system
traps such as cold start, authentication failure, etc.
TRAP
Address
Set a destination IP address of a Trap packet. If
0.0.0.0 is set, the Trap is disabled.
SysContact Set the printer manager name.
SysName Set the printer model name.
SysLocation Set the location where the printer is installed.
To Next Page
Loading...
