Configuration: Using AdminManager Standard Setup • 55
NetWare Tab (Environmental Setup)
Item Comments
Use NetWare
Protocol
Enable/disable NetWare protocol. The default is
enabled. If disabled, the search will not be carried
out using NetWare.
Auto Search If [Auto Search] is selected (the default),
AdminManager will search all networks that it can
detect.
Set Network
Number
Set network addresses that are used to search Oki
network interface cards via NetWare protocol. If
there any many NetWare file servers on your
network, specify the network address to which the
network card belongs.
Add Click to add the network number you have entered
to the list box.
Delete Select a network number in the list box, then click
[Delete] to remove it.
To Next Page
Loading...
