Oki C9600hdn

Configuration: Configurable Items • 97
Trap-16
Enable/disable sending a trap when a printer error occurs.
Trap-17
Set the node address to which a trap packet is sent. Any address.
Default is 00000000000
.
AdminManager
[Setup] → [OKI Device Setup] → [SNMP] → [Printer Trap Setup
…] → [IPX] → [Detail …] → [Trap Enable] → [Printer Error]
Web Browser
[Network] → [SNMP Trap] → [STEP3. Set Printer Trap
Assignments] → [Printer Error]
TELNET
[Setup printer trap] → [Setup IPX trap] → [Printer Error trap]
AdminManager
[Setup] → [OKI Device Setup] → [SNMP] → [Printer Trap Setup
…] → [IPX]
Web Browser
[Network] → [SNMP Trap] → [STEP2. Set Printer Trap
Address] → [IPX]
TELNET
[Setup printer trap] → [Setup IPX trap] → [IPX Trap address]