44871001TH Rev.6
4-47
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
(13) Remove two screws (Black) and separate Cover-Rear and Guide-Eject-
Upper-Assy .
(14) Remove the Gear-Idle
.
(15) Remove the Gear-Exit
(2 places), remove the Bearing-Eject_R
(2 places).
Remove the Bearing-Feeder
(2 places).
(16) Remove the Shaft-Assy-Eject
(2 places).
(17) Remove the Separator-FU
. Remove the Spring-Separator_FU .
(18) Remove the Stacker-Sensor
. Remove the Cable-Sensor-FU .
(19) Installing is performed by the inverse procedure with removing.
Note! (to assemble)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
⑰
⑱
⑲
㉒
⑳
⑳
㉑
㉓
㉘
㉚
㉙
㉗
㉕
㉕
㉔
㉔
㉖
㉛
(11) Remove the Spacer .
(12) Slide Cover Assy Rear
and pull it out of the hole on the right of the printer.
(Remove Cover Assy Rear carefully to avoid Cable-Sensor-FU from being
caught.)
To Next Page
Loading...
