Oki MB461 - 3.8 Connection Procedures

Oki Data CONFIDENTIAL
3. MFP INSTALLATION
44871001TH Rev.6
3-23
3.8 Connection Procedures
<USB Connection>
Prepare a USB Cable.
Note!
•
The cable of the MFP is not attached. Users should buy seperately.
•
Obtain the cable of USB specification by yourself.
 •
Use the USB cable of Hi-Speed specification in case the connection is to be
made using "HI-Speed" mode of USB2.0.
(2) Plug the other end of the USB cable into the computer’s USB interface connector.
Switch off the power of the
MFP
and computer.
Memo Although the USB cable can be connected or removed with the switch of the
computer and printer on, switch off the power of the MFP at this step in order
to ensure installation of the MFP driver and USB driver later.
Important •ForWindowsOSs,donot plugtheother end of theUSB cableinto
the computer until prompted while driver installation.
 •DonotplugtheUSBcableintothenetworkconnection.
  Doingsomaycauseamalfunction.
Connect the
MFP
with the computer.
(1) Plug one end of the USB cable into the USB connection on the back of the MFP.