Oki MB461 - W-LAN Board ( for Mb471 W Only)

44871001TH Rev.6
4-58
Oki Data CONFIDENTIAL
4.REPLACEMENT OF PARTS
4.2.31 W-LAN Board ( for MB451w/MB471w)
(1) Remove the Cover Side(R) and the Cover Side(L). (Refer to 4.2.1/4.2.2)
(2) Remove four Screws(Silver)
to detach the plate Shield(CU) .
LAN
ACC
①
①
②
①
①
②
②
View A
View A View B
View B
(3) Remove the LAN-Cable and the USB-Cable form the Board 98M .
③
③
④
Wire
LAN Cable
[Memo] Refer to remove the LAN-Cable
③
1. A wire should be put through to between the stopper of the LAN-Cable’s Connector and
the Board 98M.
(For example, the wire is the banding band, the aging (not useable) flat cabel or etc.)
2. Both ends of the wire should be pull to the right side of the Mainbody.
3. Check that the stopper released, and pull the LAN-Cable from the LAN Interface
Connector on the Board 98M.