Oki Data CONFIDENTIAL
44871001TH Rev.6
5-18
5. Lubricating point
2) 44596402PA Motor-Assy
44522701PP Gear-Idle
44522801PP Gear-Pulley
Detail Fig-2
44522801PP Gear-Pulley)
44522701PP Gear-Idle
44522701PP Gear-Idle
Overflow is possible
Apply to 1 place. (The application place is arbitrary)
It is application to a state without a lump jumping
out of an Gear tooth top, the tooth bottom.
EM-30LP Class C x2
It is application to each gear with MOLYKOTE
(EM-30PL) regular on the gear tooth surface
Flange convex grease application
point Grease lump possibility
(All laps)
MOLYKOTE (EM-30LP) to a side flange ( )
side in a gear tooth side.
Apply all regular laps (All laps)
44596402PA Motor-Assy
Motor Gear
⑨
44530702PA Guide-Assy-Top-B
⑩
44532401PA Guide-Assy-A
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatching area.
(All circumference of shaft)
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
SF-133 Class C
Apply a normal amount of HANARL
(SF-133) to the hatching area.
(All circumference of shaft)
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
To Next Page
Loading...
