Oki MB461 - Page 170

Oki Data CONFIDENTIAL
44871001TH Rev.6
6-15
6. MAINTENANCE MENUS
[2] [2] [2] [2] [2] [2]
A
DIAGNOSITC MODE
XX.XX.XX
-MODE
SWITCH SCAN MOTOR CLUTCH TEST TEST PRINT CONSUMABLE STATUS PRINTER STATUS
B
[8]
PAPER ROUTE : PU [8] MAIN MOTOR [8] PRINT EXECUTE [8] K-ID UNIT [8] K-TOTAL DRUM CNT
[8]
TONER SENS EXIT MOTOR FWD TEST PATTERN K-TONER TOTAL SHEET CNT
CVO UP_LU_FU EXIT MOTOR REV TEST CASSETE *1 K-STC MODE CNT
HT THERMISTER REGIST CLUTCH PAG E K OVER RIDE CNT
HUM_TEMP_DEN T1 HOP CLUTCH DUPLEX *1
TO NER TA G MPT HOP CLUTCH
*1: TRAY2 and DUPLEX are displayed
when they are installed.
T1 PE_PNE_CVO DUP FEED CLUTCH
T2 PE_PNE_CVO_CA T2 HOP CLUTCH
T2 HOP_LF_FED T2 REG CLUTCH
5V POW LV FAN TEST
FUSER FAN TEST
ID FAN TEST
Note:
If [
] is pressed when selecting a
motor, the motor keeps running.
[2] [2] [2] [2]
B
FACTORY MODE SET SENSOR SETTING L ED HE A D DATA NVRAM PARAMETER
A
FACTORY MODE [8] TONER SENSOR [8] K [8] CLEAR [8]
FUSE INTACT ID UNIT CHECK
Note :
To confirm the parameter, press [6].
DRUM OVER LIFE
WR POINT REV
BOTTOM WRT POINT
T1 DOT SHIFT
T2 DOT SHIFT
MPT/MN DOT SHIFT
Note :
To confirm the parameter, press [6].
LEVEL1
(1) How to select the menu items
Menu items can be selected by pressing either [2] or [8] key, and executed by pressing [6].
Menu items can be entered by pressing of [6] or [
4
], and can be selected by pressing of [2] or [8].
The test can be executed by pressing [6], and can be exited by pressing [4].
XXXXX
XXXXX