Oki MB461 - 7.2 Cleaning Rollers in the ADF

Oki Data CONFIDENTIAL
7. REGULAR MAINTENANCE
44871001TH Rev.6
7-4
7.2 Cleaning Rollers in the ADF
If the document feeding rollers in the ADF are contaminated with ink, toner particles or
paper dust, documents and outputs get dirty and a paper jam may occur. To prevent this, it is
recommended to clean the rollers once a month.
(1) Turn off the power of MFP.
(2) Open the ADF cover.
Note! If the rollers get too dirty, wipe them with a soft cloth lightly moistened with
neutral detergent, and then wipe it again with a soft cloth lightly moistened
with water..
(3) Wipe the document feeding rollers and surface of the Guide and the rubber pad
and the rubber sheet with a soft cloth lightly moistened with water.
Wipe the whole surface of the roller and rubber pad while turning it with your hand.
Document feed roller
Rubber Pad
Surface of the Guide
Rubber Sheet
(4) Close the ADF Cover.