Olympus OER-Pro - Chapter 7 Routine Maintenance

180
Chapter 6 Other Functions
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
6.11 Print function setup
This section describes the basic setting of the print function. As shown in Table
6.7, there are four options for printing of reprocessing records; “AUTOMATIC
PRINTING”, “PRINT LAST”, “PRINT TODAY”, “PRINT ALL”. Reprocessing
records include “Reprocessing Result” and “Error Result”. Regarding these
printing function, there are two setup menus as shown in Table 6.8.
• “Reprocessing Result” is the record provided for a completed
reprocessing process.
• “Error Result” is the record provided when an error is
encountered during a reprocessing process, which result in
an incomplete reprocessing process.
• The print function can print completed reprocessing cycles or
error codes that occur during the reprocessing cycle. It
cannot print the record of completed/incomplete
sub-independent processes and the record of error occurred
during the standby operation.
• For the printed information about “Reprocessing Result” and
“Error Result”, refer to Section 4.11, “Printing of the
reprocessing records” on page 130.
Print Function Description
AUTOMATIC
PRINTING
Prints the latest reprocessing record automatically.
PRINT LAST Prints the latest reprocessing record by manual operation of
subcontrol panel.
PRINT TODAY Prints all of the reprocessing records recorded that day by manual
operation of subcontrol panel.
PRINT ALL Prints all the reprocessing records stored in the equipment by
manual operation of subcontrol panel.
Table 6.7
Setup Menu Explanation
AUTOMATIC
PRINTING setup
Sets the “Automatic Printing function”
Refer to “Automatic Printing setup (Prints the reprocessing
records automatically)” on page 181.
Error Result
Printout setup
Sets the “Error Result Printout” on each printing option.
Refer to “Error result printout setup (for AUTOMATIC
PRINTING, PRINT TODAY and PRINT ALL)” on page 183.
Table 6.8