Chapter 7 Routine Maintenance
273
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
Performing the reprocess program
10. Insert the connector jig to the equipment and perform the reprocessing
program to disinfect the internal piping except for water supply piping. For
detailed instruction, refer to Section 4.15, “Checking functions” in
“Instructions-Installation Manual”.
Performing the water supply piping disinfection
11. Disinfect the water supply piping. For detailed instruction, refer to Section
4.17, “Disinfection of the water supply piping” in “Instructions-Installation
Manual”.
12. Olympus recommends to perform microbiological sampling of the OER-Pro
rinse water quality right after performing the water supply piping disinfection
if the device has not been used for more than 14 days. For details on
sampling rinse water, refer to Section 7.4, “Microbiological surveillance” on
page 211.
Be sure to perform routine maintenance as required
depending on the length of unused time. Otherwise, this
equipment may not continue to operate and perform as
expected. For details on routine maintenance, refer to
Chapter 7, “Routine Maintenance”.
To Next Page
Loading...
