Olympus OER-Pro - EMC Information

294
Appendix
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
EMC information
This model is intended for use in the electromagnetic environments specified
below. The user and medical staff should ensure that it is used only in these
environments.
 Magnetic emission compliance information and
recommended electromagnetic environments
Olympus confirmed that the level of this equipment’s
harmonic emissions is low.
Emission
standard
Compliance Guidance
RF emissions
CISPR 11
Group 1 This equipment uses RF (radio frequency) energy only for its internal
function. Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B This equipment’s RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
Main terminal
conducted
emissions
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Not applicable Power supply specification of this equipment is less than 220VAC, and this
equipment can be exempt from requirements of IEC 61000-3-2.
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
Not applicable Power supply specification of this equipment is less than 220 VAC, and this
equipment is exempt from requirements of IEC 61000-3-3.