222
Chapter 7 Routine Maintenance
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
1. Remove the accessory holder from the back side of the front door by
loosening the two retaining screws.
Figure 7.53
2. Using a cloth moistened with neutral detergent, clean the external surfaces
of the accessory holder and the accessories listed above, rinse them in
running water, and wipe them with a clean cloth. To prevent the spread of
various germs, it is also recommended to wipe the accessories and
accessory holder with a cloth moistened with 70% ethyl alcohol or isopropyl
alcohol.
3. Dry the accessories thoroughly and store them in a clean place near the
device.
4. Attach the accessory holder to the back side of the front door using the two
retaining screws.
To Next Page
Loading...
