Chapter 7 Routine Maintenance
249
ENDOSCOPE REPROCESSOR OER-Pro Operation Manual
3. Turn the connection ring on the equipment side of the water supply hose in
the direction shown to disconnect the hose from the equipment. If residual
water is spilled from the water supply hose, wipe it up with a clean cloth.
Figure 7.84
4. Using clean tweezers, remove the mesh filter from the water supply hose
connector.
Figure 7.85
Do not pinch the mesh filter in the water supply hose
connector too hard. This could deform the mesh filter or
injure your fingers.
Water supply hose connector
To Next Page
Loading...
