5.4 Initial Setting Leve l (1)
5-9
Parameters
5.4 Initial Setting Level (1)
Move to initial setting level (1) by selecting “1” in the initial setting level selection display and
pressing the M Key. This level is used to set the following parameters including tuning, hysteresis
for ON/OFF control. In the initial setting level (1), the ▲▼ deviation indicators are lit.
SP mode
・PV auto reset
・PV/SP display
・Tuning selection
・ST executing display
・Manual reset enable/disable
・Control period selection
Initial setting (1)
ALM mode
・Integral time setting unit
・Hysteresis width
・Temperature width in which
the ■
deviation indicator
lights
IS mode
・ST stable range
Initial setting level (1)
Page
5-10
5-12
5-13
-
1
-
1
2
ALM
ALM
SP
OUT
M
M
M
M
0
1
2ALM
ALM
SP
OUT
5
3
1
2ALM
ALM
SP
OUT
5
1
1
2ALM
ALM
SP
OUT
To Next Page
