Omron K3HB-H - Page 133

Functions and Operations
Section 5 Functions and Operations
5-60
E Press the M [MODE] Key several times
to change the PV display to “out-n.”
F Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
G Use the U [UP] Key to change the set
value.
H Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
I Press the L [LEVEL] Key for at least
1 s to return to the initial setting level.
1 s min.
J Press the L [LEVEL] Key for at least
1 s to return to RUN level.
1 s min.
M
out-n
n-o
L f
S
out-n
n-o
L f
U
out-n
n-c
L f
M
o-stp
off
L f
L
L 0
L
123. 4
123. 4