Functions and Operations
5.29 Holding Maximum and Minimum Values
5-75
5.29 Holding Maximum and Minimum Values
Each time the [MAX/MIN] Key is pressed at the RUN level, the
maximum and minimum values recorded while a measurement is
being performed will be displayed.
• Maximum and minimum values are not affected when forced-zero
and tare zero are executed or cleared.
● Switching Maximum and Minimum Value Displays
Each time the [MAX/MIN] Key is pressed in RUN level, the PV display switches as follows: present
value
→ maximum value → minimum value → present value.
* If input error enable (s.err) is ON and a sensor error occurs, the input error will be displayed on the
maximum and minimum display.
The input error is cleared by a RESET input or by pressing the [MAX/MIN] Key for at least 1 s.
● Power Interruption Memory
This function can be used to hold the maximum and minimum values
during power interruptions. The setting choices are hold and no hold.
This function can control maximum and minimum value fluctuations
even if device power is interrupted.
X V S H
Initializing
Measuring
Max. value
Min. value
Measurement status
Power supply
Initializing
Measuring
Measuring
Measuring
Measurement stopped
90000
Max
1234.5
90000
3012.6
90000
985.7
**
Min
MIN value
MAX value
Present value
To Next Page
Loading...
