Omron K3HB-H - Setting Scaling Values

Functions and Operations
Section 5 Functions and Operations
5-14
5.3 Setting Scaling Values
Set scaling to convert and display input values as any values. Inputs A
and B are set separately.
One Point* Setting Parameter for Input A
Setting Parameter for Input B (K3HB-S Only)
* The decimal point position for scaling input values depends on the
input type.
The decimal point position for scaling display values depends on the
decimal point position [dp] setting.
Initial setting level
X V S
* Use the teaching function to use actual inputs to set scaling input values “inp. a1,” “inp. a2,” “ inp.
b1,” and “inp.
b2.” Refer to “Teaching” (P.5-17) for details.
Parameter Set value Meaning of set value
Scaling input value A1
inp.
a1
-19999 to
99999*
Input value corresponding
to dsp. a1
Scaling display value A1
dsp. a1
-19999 to
99999
Display value
corresponding to inp.
a1
Scaling input value A2
inp.
a2
-19999 to
99999*
Input value corresponding
to dsp. a2
Scaling display value A2
dsp. a2
-19999 to
99999
Display value
corresponding to inp.
a2
Parameter Set value Meaning of set value
Scaling input value B1
inp.b1
-19999 to
99999*
Input value corresponding
to dsp.b1
Scaling display value B1
dsp.b1
-19999 to
99999
Display value
corresponding to inp.b1
Scaling input value B2
inp.b2
-19999 to
99999*
Input value corresponding
to dsp.b2
Scaling display value B2
dsp.b2
-19999 to
99999
Display value
corresponding to inp.b2
Parameter Set value Meaning of set value
Decimal point position
dp
,,,,, No decimal point
,,,,., One digit below the decimal
point is displayed.
,,,.,, Two digits below the decimal
point are displayed.
,,.,,, Three digits below the
decimal point are displayed.
,.,,,, Four digits below the decimal
point are displayed.
k
L 0
(K)
dsp. b2
L 0
(DSP.B2)
inp. a1
L 0
(INP.A1)
dp
L 0
(DP)
dsp. b1
L 0
(DSP.B1)
dsp. a2
L 0
(DSP.A2)
dsp. a1
L 0
(DSP.A1)
inp. b2
L 0
(INP.B2)
inp. b1
L 0
(INP.B1)
inp. a2
L 0
(INP.A2)