Functions and Operations
Section 5 Functions and Operations
5-26
5.7 Resetting Measurements
When the RESET input turns ON or the [MAX/MIN] Key is pressed
for at least 1 s, the maximum value, minimum value, and outputs are
cleared. Measurement is not performed during RESET input.
• The display during RESET input is “-----” and all outputs are
OFF.
• HOLD and TIMING inputs are accepted, but measurement is
disabled during RESET input.
• The RESET input is disabled during “serr.”
Not performing measurements for set intervals
→ P.5-27
X V S H
HH/H
LL/L
RESET input
Min.
value
Max.
value
No measurement
status
Comparative
set value HH/H
Comparative
set value LL/L
Output
Output
Measurement
value
Remarks
To Next Page
Loading...
