Omron K3HB-H - Displaying;Not Displaying Comparative Set Values

Functions and Operations
Section 5 Functions and Operations
5-82
5.32 Displaying/Not Displaying Comparative Set
Values
Comparative set values can be displayed or not displayed on the SV
display during operation.
This is set using the following parameter.
If “comparative set value display” is set to OFF, the comparative set
value display will turn OFF (not be lit) after 10 s in RUN level. The
comparative set value is displayed again when any key is pressed.
Parameter Setting Procedure
Display adjustment level
Parameter Set value Meaning of set value
Comparative set value
display
sv.dsp
off Comparative set value not
displayed.
on Comparative set value
displayed.
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
•“L 0 ” is displayed on the level/bank
display to indicate the initial setting
level.
B Press the L [LEVEL] Key several
times to move to the display adjustment
level.
•“
L 2” is displayed on the level/bank
display to indicate the display
adjustment level.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] Key to change the set
value.
E Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
F Press the L [LEVEL] Key for at least
1 s to return to RUN level.
1 s min.
X V S H
sv. dsp
L 2
(SV.DSP)
L
Displays “L 0.”
L 0
L
Displays “L 2."
L 2
sv. dsp
off
S
sv. dsp
off
L 2
U
sv. dsp
on
L 2
M
d. ref
off
L 2
L
123. 4
123. 4