Omron K3HB-H - Performing Linear Output

Functions and Operations
5.24 Performing Linear Output
5-63
5.24 Performing Linear Output
The linear output function outputs currents or voltages proportional to
measurement values as they change.
Select the type of linear output. Set the maximum and minimum output
measurement values to output the current or voltage for those
measurement values.
Voltage Output
Current Output
* Areas marked with an asterisk (*) are input error areas. If the “operation at
input error” parameter is set to “input error,” then the output would be like
Line B. Otherwise, the output would be like Line A.
* If operation stops without performing a measurement, then the minimum
value (e.g., 4 mA for the 4 to 20 mA range) is output.
* The value set for the upper limit does not necessarily have to be higher than
the value set for the lower limit. The following is an example of reverse
scaling.
Linear output level
X V S H
lset. c
L s
(LSET.C)
lset. v
L s
(LSET.V)
lset. h
L s
(LSET.H)
lset. l
L s
(LSET.L)
5 or 10 V
0 V
Linear output
lower limit
Linear output
upper limit
Line A
Line B
Line A
Line B
Linear output
lower limit
Linear output
upper limit
5 V
1 V
Measurement
value
Measurement
value
Linear output
Linear output
20 mA
0 mA
Line A
Line B
Line A
Line B
20 mA
4 mA
Linear output
lower limit
Linear output
upper limit
Linear output
lower limit
Linear output
upper limit
Measurement
value
Measurement
value
Linear output
Linear output
Line A
20 mA
4 mA
Line B
Linear output
lower limit
Linear output
upper limit
Measuremen
t
value
Linear output