Omron K3HB-H - Holding Measurement Status

Functions and Operations
Section 5 Functions and Operations
5-54
5.19 Holding Measurement Status
Measurement values, maximum values, minimum values, and output
status can be held while the HOLD input is ON.
• The measurement value is held when the HOLD input turns ON.
• When the HOLD input turns OFF, the measurement value at that
time is restored.
• During HOLD input, signals other than RESET input and bank
number selection using bank selection are not accepted.
• If the HOLD input turns ON in no measurement status, when a
sensor error has occurred, or when there is an overflow, the status
at that time is held.
• Forced-zero is not accepted during HOLD input.
X V S H
HOLD input
Comparative
set vaLue HH/H
Comparative
set value LL/L
Output HH/H
Output LL/L