Omron K3HB-H - Reversing Output Logic

Functions and Operations
5.22 Reversing Output Logic
5-59
5.22 Reversing Output Logic
The output logic reversal function sets the logic of comparative outputs
for comparative results.
The comparative outputs will turn OFF if an input error occurs when
“open in alarm” is set.
* Turns OFF when an input error occurs.
Parameter Setting Procedure
Advanced function setting level
Parameter
Set
value
Operation
Comparative
result
Comparative
output status
Comparative
output
Output
logic
out-n
Close in
alarm
n-o
ON ON ON
OFF OFF OFF
Open in
alarm
n-c
ON ON OFF
OFF OFF ON*
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
•“L 0 ” is displayed on the level/bank
display to indicate the initial setting
level.
B Press the M [MODE] Key several times
to change the PV display to “amov.”
• This parameter is not displayed for
the initial status due to setting level
protect.
Refer to "Limiting Key Operations"
(P.5-102) for information on removing
setting level protect.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] and S [SHIFT] Keys
to set the password “-0169.” Press the
M [MODE] Key to move to the
advanced function setting level.
•“
L f” is displayed on the level/bank
display to indicate the advanced
function setting level.
X V S H
out-n
L f
(OUT-N)
L
Displays “L 0.”
L 0
M
amov
0
L 0
S
amov
00000
L 0
SU
M
init
Displays “L f.”
off
L f