Functions and Operations
Section 5 Functions and Operations
5-90
5.36 No Decimal Point Display
This function selects whether or not to display values below the
decimal point for present values, maximum values, and minimum
values.
If no display is selected, then numbers past the decimal point are
rounded off to display the nearest integer. Comparative judgments,
however, will use the decimal point.
Parameter Setting Procedure
Display adjustment level
Parameter Set value Meaning of set value
Decimal point display
pvdp
on 23.5 (Decimal point display)
off 24 (No decimal point display)
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
•“L
0
”
is displayed on the level/bank
display to indicate the initial setting
level.
B Press the L [LEVEL] Key several
times to move to the display adjustment
level.
•“
L 2” is displayed on the level/bank
display to indicate the display
adjustment level.
C Press the M [MODE] Key several times
to change the PV display to “
pvdp
.”
D Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U [UP] Key to change the
position meter type setting.
F Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
H
pvdp
L 2
(PVDP)
L
Displays “L 0.”
L 0
L
Displays “L 2."
L 2
sv. dsp
off
M
pvdp
off
L 2
S
L 2
pvdp
off
SU
L 2
pvdp
on
M
sv. dsp
off
L 2
To Next Page
Loading...
