Omron K3HB-H - Automatic Return to Normal Display

Functions and Operations
Section 5 Functions and Operations
5-88
5.35 Automatic Return to Normal Display
If no keys are operated for a specified time after switching the display
in the RUN level or adjustment level, the display will automatically
return to the RUN level. The time until the display returns automatically
can be set and the automatic display return can be disabled through
this setting.
Automatic display return settings are made using the following
parameter.
Parameter Setting Procedure
Display adjustment level
Parameter Set value Meaning of set value
Automatic display return
ret
0 to 99 0 to 99 s
Automatic display return will
not occur if set to 0.
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
•“L 0 ” is displayed on the level/bank
display to indicate the initial setting
level.
B Press the L [LEVEL] Key several
times to move to the display adjustment
level.
•“
L 2” is displayed on the level/bank
display to indicate the display
adjustment level.
C Press the M [MODE] Key several times
to change the PV display to “ret.”
D Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U [UP] and S [SHIFT] Keys
to change the set value.
F Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
X V S H
ret
L 2
(RET)
L
Displays “L 0.”
L 0
L
Displays “L 2."
L 2
sv. dsp
off
M
ret
10
L 2
S
ret
10
L 2
SU
03
L 2
ret
M
pos-t
inc
L 2