Omron K3HB-H - Section 5 Functions and Operations

Functions and Operations
5-1
Section 5 Functions and Operations
Knowledge Required for Setting Parameters........................................... 5-2
------ Operation Adjustments ---------------------------------------------------------------
5.1 Setting Calculations ......................................................................... 5-9
5.2 Setting Input Types .......................................................................... 5-11
5.3 Setting Scaling Values ..................................................................... 5-14
5.4 Setting the Temperature Unit ........................................................... 5-18
5.5 Setting Measurement Operations .................................................... 5-19
5.6 Shifting the Temperature Input......................................................... 5-24
5.7 Resetting Measurements................................................................. 5-26
5.8 Not Performing Measurements for Set Intervals.............................. 5-27
------ Input Adjustments----------------------------------------------------------------------
5.9 Selecting Operations for Input Errors............................................... 5-29
5.10 Disabling Cold Junction Compensation ........................................... 5-31
5.11 Adjusting Timing Inputs ................................................................... 5-33
5.12 Eliminating Drift Near “0” ................................................................. 5-36
5.13 Averaging Inputs .............................................................................. 5-38
5.14 Detecting Sudden Input Changes.................................................... 5-41
------ Output Adjustments -------------------------------------------------------------------
5.15 Changing Comparative Output Patterns .......................................... 5-44
5.16 Preventing Output Chattering .......................................................... 5-46
5.17 Outputting for a Set Interval............................................................. 5-49
5.18 Delaying Output OFF Timing ........................................................... 5-52
5.19 Holding Measurement Status .......................................................... 5-54
5.20 Holding Comparative Outputs.......................................................... 5-55
5.21 Allocating Another Output to PASS Output...................................... 5-57
5.22 Reversing Output Logic ................................................................... 5-59
5.23 No Output before PASS Range........................................................ 5-61
5.24 Performing Linear Output................................................................. 5-63
------ Display Adjustments ------------------------------------------------------------------
5.25 Setting the Present Measurement Value to “0”................................ 5-65
5.26 Setting the Present Measurement Value to “0” Again when Using a Forced Zero 5-67
5.27 Compensating Forced-zero References .......................................... 5-70
5.28 Changing Display Refresh Periods .................................................. 5-73
5.29 Holding Maximum and Minimum Values.......................................... 5-75
5.30 Changing Normal Display Values to Maximum and Minimum Values 5-78
5.31 Setting the Step for Changing the Rightmost Digit .......................... 5-80
5.32 Displaying/Not Displaying Comparative Set Values......................... 5-82
5.33 Changing Display Colors ................................................................. 5-83
5.34 Using the Position Meter.................................................................. 5-85
5.35 Automatic Return to Normal Display................................................ 5-88
5.36 No Decimal Point Display................................................................. 5-90
------ Other Operations -----------------------------------------------------------------------
5.37 Performing Output Tests .................................................................. 5-92
5.38 Using Comparative Set Value Banks ............................................... 5-93
5.39 Copying Bank Comparative Set Values ........................................... 5-98
5.40 Initializing All Settings ...................................................................... 5-100
5.41 Limiting Key Operations................................................................... 5-102