Functions and Operations
Section 5 Functions and Operations
5-10
■ B/A × 10000
• Select to display the ratio between input A and input B.
■ (B/A-1) × 10000
• Select to display the error ratio for input B and input A.
Set using the following parameter.
Parameter Setting Procedure
Setting constant K. → P.5-16
Parameter Set value Meaning of set value
Calculation
cal
0 A
1 B
2 K-A
3 A+B
4 A-B
5 K-(A+B)
6 B/A
× 10000
7 (B/A-1)
× 10000
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
3 s min.
•“L
0
”
is displayed on the level/bank
display to indicate the initial setting
level.
B Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
C Use the U [UP] Key to change the set
value.
D Press the M [MODE] Key to switch to
the next PV display.
• The set value is registered.
cal
L 0
(CAL)
L
cal
0
Displays “L 0.”
L 0
S
cal
0
L 0
U
cal
2
L 0
M
in-ta
,,.,,,
L 0
Remarks
To Next Page
Loading...
