Functions and Operations
5.5 Setting Measurement Operations
5-21
Bottom Hold
• The minimum value is held while measurement is being
performed (while the TIMING input is ON) and when the
measurement has been completed (when the TIMING input turns
OFF) the measurement value is refreshed using the held
minimum value.
Important* • When the measurement value exceeds the measurement range
during measurement, a sensor error will occur, a sensor error will
immediately show on the display, and all outputs will turn OFF.
Also, the measurement at that time will be invalid.
• Measurements are not performed during RESET input and
TIMING inputs are disabled.
The PV display will show “-----” in no measurement status.
Selecting operations for input errors
→ P.5-29
Operation will continue if input error enable is set to OFF (disabled) or
OVER (overflow).
TIMING
RESET
Measurement value
Power ON
No measurement
No measurement
Bottom value 1
Measurement
period
Input error
Measurement invalid because a sensor
error occurred during measurement.
Measurements during
reset input are invalid.
Measurement
range lower limit
A sensor error occurs and all outputs are turned OFF
if the measurement range is exceeded.
Remarks
To Next Page
Loading...
