Omron K3HB - Changing Normal Display Values to Maximum and Minimum Values

Functions and Operations
Section 5 Functions and Operations
5-62
5.25 Changing Normal Display Values to Maximum
and Minimum Values
The PV display value after the power has been turned ON,
immediately after moving to RUN level, or immediately after automatic
display return in RUN or adjustment levels can be set to either
"present value", "maximum value", or "minimum value".
"Display value selection" is set using the following parameter.
Parameter Setting Procedure
Displaying/not displaying comparative set values → P.5-64
Using position meters → P.5-67
Changing automatic display return time → P.5-60
Display adjustment level
Parameter Set value Meaning of set value
Display value selection
disp
pv Present value
max Max. value
min Min. value
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
• "
L
0" is displayed on the level/bank
display to indicate the initial setting level.
B Press the L[LEVEL] Key several times
to move to the display adjustment level.
•
"
L
2
" is displayed on the level/bank display
to indicate the display adjustment level.
C Press the M[MODE] Key to change the
PV display to "disp".
D Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U[UP] Key to change the set
value.
F Press the M[MODE] Key to switch to
the next parameter.
• The set value is registered.
G Press the L[LEVEL] Key for at least 1
s to return to RUN level.
1 s min.
disp
L 2
(DISP)
L
cal
0
Displays "
L
0".
L 0
L
sv. dsp
off
Displays "
L
2".
L
2
M
disp
pv
L
2
S
disp
pv
L
2
U
disp
max
L
2
M
ret
10
L
2
L
123. 4
123. 4
Remarks