Omron K3HB - Using Position Meters

Functions and Operations
5.29 Using Position Meters
5-67
5.29 Using Position Meters
The meters on the right side of the front panel with 20 sections is
called the "position meter" and shows the position of the displayed
value (present value, maximum, or minimum) in relation to any values
set using position meter upper and lower limits.
The position meter upper and lower limits can be set to any values.
The position meter display pattern is set using the following parameter.
*1. The decimal point depends on the "decimal point position"
parameter setting.
*2. The amount that the displayed value differs from the mid-point
between the position meter upper and lower limits (the deviation) is
displayed.
* If the position meter lower limit set value is smaller than the position
meter upper limit set value, the top and bottom of the above displays
will be reversed.
Display adjustment level
Parameter Set value Meaning of set value
Position meter type
pos-t
off Position meter not displayed
inc Incremental
inc-r Incremental (reversed)
dev Deviation *2
dev-r Deviation (reversed)
Position meter upper limit
pos-h
-19999 to
99999
-19999 to 99999 (*1)
Position meter lower limit
pos-l
-19999 to
99999
-19999 to 99999 (*1)
Position meter
type
Incremental
Incremental
(reversed)
Deviation
Deviation
(reversed)
Position meter
upper limit
Position meter
lower limit
pos-t
L 2
(POS-T)
pos-l
L 2
(POS-L)
pos-h
L 2
(POS-H)
Present value: 40
DecreaseIncrease Present value
Present value: 40
DecreaseIncrease Present value
DecreaseIncrease Present value
Present value: 70 Present value: 70
DecreaseIncrease Present value