Omron K3HB - Copying Bank Comparative Set Values

Functions and Operations
5.33 Copying bank comparative set values
5-77
5.33 Copying bank comparative set values
The bank copy function is used to specify a bank between 0 and 7 and
copy the group of comparative set values in that bank to all banks.
Parameter Setting Procedure
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
• "
L
0" is displayed on the level/bank
display to indicate the initial setting level.
B
Press the L[LEVEL] Key several times to
move to the comparative set value level.
•"
L
4" is displayed on the level/bank
display to indicate the comparative
set value level.
C Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U[UP] Key to select the bank
to be copied from.
E Press the M[MODE] Key to switch to
the next parameter.
• Change the comparative set values
HH, H, L, and LL as required.
F Press the M[MODE] Key several times
to change the PV display to "copy".
G Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
H Use the U[UP] Key to change the SV
display to "on".
I Press the M[MODE] Key to switch to
the next parameter.
• The comparative set value from the
copy source bank selected in step D
will be copied to all banks.
copy
L
4
(COPY)
L
cal
0
Displays "
L
0".
L
0
L
sv. bnk
Displays "
L
4".
0
L
4
S
sv. bnk
0
L
4
U
sv. bnk
1
L
4
M
sv1. hh
10000
L
4
M
copy
off
L
4
S
copy
off
L
4
U
copy
on
L
4
M
sv. bnk
0
L
4