Omron K3HB - Section 5 Functions and Operations; Table of Contents

Functions and Operations
5-1
Section 5 Functions and Operations
Knowledge Required for Setting Parameters.................................... 5-2
-----Operation Adjustments -----------------------------------------------------
5.1 Setting Calculations ................................................................... 5-9
5.2 Setting Input Types.................................................................. 5-11
5.3 Setting Scaling Values............................................................. 5-12
5.4 Setting Measurement Operations ............................................ 5-16
5.5 Resetting Measurements......................................................... 5-20
5.6 Not Performing Measurements for Set Intervals...................... 5-21
-----Input Adjustments ------------------------------------------------------------
5.7 Selecting Operations for Input Errors ...................................... 5-23
5.8 Adjusting Timing Inputs ........................................................... 5-25
5.9 Eliminating Drift Near "0" ......................................................... 5-28
5.10 Averaging Inputs.................................................................... 5-30
5.11 Detecting Sudden Input Changes.......................................... 5-33
-----Output Adjustments----------------------------------------------------------
5.12 Changing Comparative Output Patterns................................ 5-36
5.13 Preventing Output Chattering ................................................ 5-38
5.14 Outputting at Set Intervals ..................................................... 5-41
5.15 Delaying Output OFF Timing................................................. 5-44
5.16 Holding measurement status ................................................. 5-46
5.17 Holding Already Output Comparative Outputs....................... 5-47
5.18 Allocating Other Outputs to PASS Output ............................. 5-49
5.19 Reversing Output Logic ......................................................... 5-51
-----Display Adjustments---------------------------------------------------------
5.20 Setting the present measurement value to a reference
value of "0"............................................................................. 5-53
5.21 Setting the present measurement value to "0" again using
the forced-zero reference ...................................................... 5-54
5.22 Compensating Forced-zero References................................ 5-57
5.23 Changing Display Refresh Periods........................................ 5-60
5.24 Holding maximum and minimum values ................................ 5-61
5.25 Changing Normal Display Values to Maximum and
Minimum Values .................................................................... 5-62
5.26 Setting the Step for Changing the Rightmost Digit ................ 5-63
5.27 Displaying/Not Displaying Comparative Set Values .............. 5-64
5.28 Changing Display Colors ....................................................... 5-65
5.29 Using Position Meters............................................................ 5-67
5.30 Forcing Automatic Return to Normal Display......................... 5-70
-----Other Operations--------------------------------------------------------------
5.31 Performing Output Tests........................................................ 5-71
5.32 Using Comparative Set Value Banks..................................... 5-72
5.33 Copying bank comparative set values ................................... 5-77
5.34 Initializing all settings ............................................................. 5-78
5.35 Limiting Key Operations......................................................... 5-80