Functions and Operations
Section 5 Functions and Operations
5-78
5.34 Initializing all settings
Important *
Initialization can be used to start settings over again from the default
settings. Refer to Parameter List in the Appendices for information on
default set values.
Parameter Setting Procedure
* If this operation is performed, all parameters return to the initial settings and current settings are
lost. It is recommended that before performing this operation, the Parameter List at the end of this
manual or some other method is used to record the current set values.
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
•
"
L
0" is displayed on the level/bank
display to indicate the initial setting level.
B Press the M[MODE] Key several times
to change the PV display to "amov".
•
This parameter is not displayed for the
initial status due to setting level protect.
Refer to "Limiting Key Operations" (P.5-
80) for information on removing setting
level protect.
C Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D
Use the
U
[UP] and
S
[SHIFT] Keys to set
the password
"
-0169
". Press the
M
[MODE] Key to move
to the advanced-function setting level.
•"
L
f" is displayed on the level/bank
display to indicate the advanced-
function setting level.
E Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
F Use the U[UP] Key to change the SV
display to "on".
G
Press the M[MODE] Key to switch to the
next parameter and execute initialization.
• The set value is registered.
init
L
f
(INIT)
L
cal
0
Displays "
L
0".
L
0
M
amov
0
L
0
S
amov
00000
L
0
SU
M
init
Displays "
L
f".
off
L
f
S
init
off
L
f
U
init
on
L
f
M
pass
pass
L
f