Appendices
Appendices
A-18
No Measurement Status
When no measurement value has been determined, a "no
measurement" status exists. The PV display for no measurement is "-
----" and all outputs are OFF.
A no measurement status occurs in the following circumstances.
• Immediately after turning ON the power.
• Immediately after returning to RUN level from any level other than
protect and adjustment levels.
• When the reset signal is ON.
• When the [MAX/MIN] Key is pressed for 1 s min.
• While the startup compensation timer is operating.
* If the hold signal turns ON when no measurement has been made,
the no measurement status is held.
88888
-----
8
· PV display "-----"
· All outputs OFF
To Next Page
Loading...
