User Calibr
ation
Section 6 User calibration
6-2
6.1 About user calibration
The K3HB-S is calibrated correctly at shipment, so there is normally no
need for the user to calibrate it.
The K3HB-S has a function to calibrate analog inputs that can be used
for user calibration.
OMRON, however, does not accept any responsibility for the results of
user calibration using this function.
Each time data is calibrated, earlier calibration data is overwritten. Be
careful, therefore, because default data is lost when the K3HB-S is
calibrated by the user.
Prepare measuring instruments and equipment for calibration
separately. Refer to each manual for the instruments and equipment
for information on handling the instruments and equipment.
To Next Page
Loading...
