III
● Precautions
CAUTION
Do not touch the terminals while power is being supplied.
Doing so may result in electric shock.
Do not disassemble the product or touch internal parts while
power is being supplied.
Doing so may result in electric shock, fire, or malfunction.
Perform correct setting of the product according to the application.
Failure to do so may cause unexpected operation, resulting in
injury or damage to the installation.
Ensure safety in the event of product failure by taking safety
measures, such as installing a separate monitoring system.
Product failure may prevent operation of comparative outputs and
result in a serious accident unless appropriate safety measures
are taken.
Do not allow pieces of metal or wire clippings to enter the product.
Doing so may result in electric shock, fire, or malfunction.
Do not use the product in locations where flammable or explosive
gases are present.
Do not use the equipment for measurements within measurement
categories II,III and IV.
Doing so may result in injury or damage to the installation.
(according to IEC61010-1)
To Next Page
Loading...
