Omron K3HB - Page 59

Functions and Operations
5.4 Setting Measurement Operations
5-19
Parameter Setting Procedure
Adjusting timing inputs → P.5-25
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
•"
L
0" is displayed on the level/bank
display to indicate the initial setting
level.
B Press the L[LEVEL] Key again (less
than 1 s) to move to the input
adjustment level and display "tmg-h".
1 s max.
•"
L
1" is displayed on the level/bank
display to indicate the input
adjustment level.
C Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U[UP] Key to change the set
value.
E Press the M[MODE] Key to switch to
the next parameter.
• The set value is registered. * The display may
differ.
F Press the L[LEVEL] Key for at least 1
s to return to RUN level.
1 s min.
L
cal
0
Displays "
L
0".
L
0
L
tmg-h
L
1
Displays "
L
1".
nomal
S
tmg-h
L
1
nomal
U
tmg-h
s-h
L
1
M
on-t
0
L
1
L
-----
123. 4
Remarks