Omron K3HB - Page 66

Functions and Operations
Section 5 Functions and Operations
5-26
● Timing hold set value set to peak hold
Parameter Setting Procedure
20 ms 20 ms 20 ms
10 ms 10 ms10 ms
TIMING
RESET
Measurement
value
Power ON
Peak value 1 Peak value 2No measurement No measurement
Delay processing invalid
due to reset input.
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
•"
L
0" is displayed on the level/bank
display to indicate the initial setting
level.
B Press the L[LEVEL] Key again (less
than 1 s) to move to the input
adjustment level.
1 s max.
•"
L
1" is displayed on the level/bank
display to indicate the input
adjustment level.
C Press the M[MODE] Key several times
to switch the PV display to "on-t".
D Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U[UP] and S[SHIFT] Keys to
change the ON timing delay time.
• Units: ms
F Press the M[MODE] Key to switch the
PV display to the next parameter "off-
t".
• The parameter "on-t" is registered.
G Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
L
cal
0
Displays "
L
0".
L
0
L
tmg-h
Displays "
L
1".
s-h
L
1
M
on-t
0
L
1
S
on-t
0000
L
1
SU
on-t
0020
L
1
M
off-t
0
L
1
S
off-t
0000
L
1