Omron K3HB - Page 79

Functions and Operations
5.13 Preventing Output Chattering
5-39
Parameter Setting Procedure
A Press the L[LEVEL] Key for at least 3
s in RUN level to move to the initial
setting level.
3 s min.
•"
L
0" is displayed on the level/bank
display to indicate the initial setting
level.
B Press the M[MODE] Key several times
to change the PV display to "amov".
•
This parameter is not displayed for the
initial status due to setting level
protect.
Refer to "Limiting Key Operations"
(P.5-80) for information on removing
setting level protect.
C Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U[UP] and S[SHIFT] Keys to
set the password "-0169". Press the
M[MODE] Key to move to the
advanced-function setting level.
•"
L
f" is displayed on the level/bank
display to indicate the advanced-
function setting level.
E Press the M[MODE] Key several times
to change the PV display to "hys".
F Press the S[SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
G Use the U[UP] and S[SHIFT] Keys to
change the set value.
H Press the M[MODE] Key to switch to
the next parameter.
• The set value is registered.
I Press the L[LEVEL] Key for at least 1
s to return to the initial setting level.
1 s min.
L
cal
0
Displays "
L
0".
L 0
M
amov
0
L
0
S
00000
L
0
amov
SU
M
init
Displays "
L
f".
off
L
f
M
hys
1
L
f
S
hys
0001
L
f
SU
hys
0050
L
f
M
off-d
0
L
f
L
cal
0
L
0