VII
● Revision History
The revision code of this manual is given at the end of the catalog number at the
bottom left of the back cover.
Cat. No. N110-E1-02
Revision
code
Date Pages and changes
01 March
2003
Original production
02 September
2003
Page 1-2: Changed “High-pass filter” to “Previous Average Comparison”.
Page 5-16: Added a conditional statement to the Remarks.
Page 5-17: Added Remarks at the end of Sampling hold and Peak hold.
Page 5-18: Added Remarks at the end of Bottom hold and Peak-to-peak
hold.
Page 5-18: Changed “Sensor error” to “Input error” in the top graphic.
Page 5-18: Changed “input error enabled” to “operation at input error” in the
note at the bottom of the page.
Page 5-23: Changed the description at the top of the page.
Page 5-23: Added a table for “Disabled”, changed the titles to “Overflow”
and “Input error”, and changed the description for Output under Overflow.
Page 5-24: Changed the seven segment displays for step E and F.
Page 5-24: Changed the seven segment display from ON to OFF for step
G.
Page 5-28: Deleted a sentence from the second paragraph from the top of
the page.
Page 5-33: Changed “high-pass filter” to “previous average comparison” in
five locations.
Page 5-34: Changed “High-pass filter” to “Previous average comparison” in
the first paragraph.
Page 5-34: Added a few lines below the top table.
Page 5-34: Changed the contents of the parameter table.
Page 5-35: Added “Example of Previous Average Comparison for
Sampling Hold”.
Page 5-49: Changed the description in the note with an asterisk under the
parameter table for PASS output change.
Page 5-61: Changed the description in the note with an asterisk under
Switching maximum and minimum value displays.
Page A-2: Changed “high-pass filter” to “previous average comparison” for
Other functions.
Page A-7: Changed the seven segment display under Initial value for
Comparative output pattern.
Page A-8: Changed the seven segment display under Initial value for
Average type.
Page A-8: Deleted units for Position meter upper limit and Position meter
lower limit.
Page A-10: Changed “high-pass filter” to “previous average comparison”
and “input error enabled” to “operation at input error” for Advanced function
settings. Changed the seven segment displays for Operation at input error.
Page A-11: Changed “high-pass filter” to “previous average comparison”
and “input error enabled” to “operation at input error” for Advanced function
settings. Deleted the description under Setting Conditions for Zero-limit.
Page A-12: Changed “high-pass filter” to “previous average comparison”
and “input error enabled” to “operation at input error” in the flow diagram for
Advanced function setting level. Changed the seven segment display and
the setting range for Operation at input error in the same flow diagram.
Page A-16: Changed the calculation formula from A to A+B for Example 5.
Index: Deleted “High-pass filter” and added “Previous average
comparison”.
Index: Deleted “Input error enabled” and added “Operation at input error”.
To Next Page
Loading...
Need help?
General
