Omron M1 Series User Manual

Item No.
Pa-
rame-
ter
No.
Item Range Display item
5_10 W82
Data Used Integrat-
ing Electric Power
0.001 to 9999
The integrated electric power consumption
(1.000 = 100 kWh) × Display Coefficient for
Integrated Power (E51) is displayed as the in-
tegrated electric power data.
The setting range of Display Coefficient for
Integrated Power (E51) is 0.000 to 9999.
Display unit: None
If 9999 is exceeded, the display remains as
9999.
The decimal point position moves depending
on the size of the integrating electric power
data, and the display resolution changes. The
integrating electric power data can be reset
by setting parameter E51 to “0.000.” Integra-
tion is not performed when 0.000 is still set.
5_1
1 W83
Number of Operator
Comm Errors
0 to 9999 [errors]
The number of errors after turning ON the
power is accumulated and displayed. If the
number of errors exceeds 9,999, the value re-
turns to 0.
5_12 W84
Contents of Operator
Comm error
0 to 127
The latest errors that occur in the Digital Op-
erator are displayed in a decimal code.
5_13 W95 Reserved - -
5_14 W87
Inverter ROM Version
1 Main
x.xx.xx
x.xx (upper three digits) and xx (lower two
digits) are displayed alternately
.
5_15 W88
Inverter ROM V
ersion
2 Sub
x.xx.xx
x.xx (upper three digits) and xx (lower two
digits) are displayed alternately.
5_16 W89
ROM V
ersion Opera-
tor
0 to 9999
The version of the Operator is displayed.
5_17 W85
Number of RS-485
Errors
0 to 9999
If the cumulative value of the number of er-
rors after turning ON the power reaches
9999, the value returns to 0.
5_18 W94
Contents of RS-485
Error
0 to 127
The error code of the final communication er-
ror that has occurred in the SP-SN terminal is
displayed in hexadecimal.
5_19 - - - -
5_23 Z40
1st Cumulative Run
T
ime
0 to 9999 [x10h]
The cumulative time of the 1st motor run time
is displayed.
Measurement range: 0 to 99,990 hours
(Cumulative operation time of motor = Dis-
play × 10 hours)
If 99,990 hours is exceeded, the value returns
to 0 and the calculation continues.
7 Other Functions
7-15
M1 Series Standard Type User's Manual (I669)
7-1 Status Monitors
7
7-1-3 Maintenance Information

Omron M1 Series Specifications

General

Input Voltage	200-240V AC
Output Voltage	3-phase 200 to 240 VAC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Communication	RS-485, Modbus RTU
Enclosure	IP20
Cooling Method	Fan Cooled
Operating Temperature	-10°C to +50°C
Humidity	5-95% (non-condensing)
Altitude	Up to 1000m
Frequency Range	0.5-400 Hz
Storage Temperature	-20°C to +65°C