103
OS32C
User’s Manual
Chapter4
Installation
E
OS32C with Simple Mounting Bracket and Top Guard Kit Dimensional Drawing
Fig. 4-24 Dimensional drawing of OS32C with OS32C-BKT3 and OS32C-BKT4
OS32C with Simple Mounting Bracket and Top Guard Kit Assembly Drawing
Fig. 4-25 Assembly drawing of OS32C with OS32C-BKT3 and OS32C-BKT4
(X4) (M5 x 16)
MOUNTING SCREWS
(X4) (M5)
WASHERS, FLAT
(X2)
SIMPLE MOUNTING
BRACKET
OS32C LASER SCANNER UNIT
MODEL OS32C-BP/OS32C-BP-DM
TOP GUARD
I/O CABLE
(X4) SLOTS
M5 SCREWS, SPLIT AND FLAT WASHERS
HARDWARE USER SUPPLIED *
* In order to comply with Section 4.2.16 of IEC 61496-3, when the OS32C is mounted where the scanner position could change
(e.g. as the result of an impact), additional mechanical means, such as serrated or toothed lock washers, must be employed
in the mounting hardware.
MODEL OS32C-SP1/OS32C-SP1-DM
OS32C LASER SCANNER UNIT
(TO ALLOW FOR CONNECTOR CLEARANCE).
USE OPEN END HEX WRENCH TOOL TO FASTEN SCREWS
BEFORE ATTACHING THIS BRACKET TO UNIT.
INSERT HEX HEAD HARDWARE INTO BRACKET SLOTS
To Next Page
Loading...
