37
OS32C
User’s Manual
Chapter3
Basic Operation of Configuration Software
E
Tool Bars
Fig. 3-2
Table 3-7
Fig. 3-3
Table 3-8
(1) Create a new configuration Used to create new configuration of OS32C
(2) Open configuration from file Opens a configuration information file saved on PC
(3) Save configuration to file Saves created configuration information on PC
(4) Print configuration Prints OS32C configuration information
(5) System Monitoring Shows current scanning zone information on the zone information screen in real-time
(6) Sculpting Enable/disable sculpting mode
(7) Record system monitoring Record OS32C scanning zone information
(8) Playback system monitoring Playback previously recorded OS32C scanning zone information
(1) Change measurement unit Change unit of measure (mm, cm, or inches)
(2) Zoom in Magnifies the zone information screen
(3) Zoom out Minimizes the zone information screen
(4) Zoom window Magnifies a specific area of the zone information screen
(5) View center Shows the zone information screen with the OS32C in the center
(6) View all Shows the zone information screen with minimum zoom
(7) Toggle view panning
Enables/Disables view panning (Allow a user to click on the displayed zone and move
their mouse to adjust their view of the zone).
(8) Edit zone Enables/Disables the editing of zones
(9) Convert shape to Convert zone being edited to a circular segment, polygon, or rectangle
(10) Undo Undo last action
(11) Redo Redo last action
(12) Add zone Add a new zone to the configuration
(13) Copy zone Copy the zone currently selected (in the foreground).
(14) Paste zone Paste a copied zone to the zone currently selected (in the foreground).
(15) Flip view horizontally Changes the PC screen view in a horizontal direction
(16) Flip view vertically Changes the PC screen view in a vertical direction
To Next Page
Loading...
